Author Archives: glent

About glent

Glen Taylor is the owner of eWerks Inc. (www.ewerksinc.com) for over 25 years he has been involved in the design and manufacture of industrial electronics. Glen holds a Master of Science degree (with distinction) in Electronic Product Development from the University of Bolton in the UK, a CID certification in circuit board design from IPC Designers Council, and is an authorized Microchip Design Partner. He is also a senior member of IEEE - Institute of Electrical and Electronic Engineers and ISA - International Society for Automation. In his spare time he is a licensed PADI open water SCUBA instructor.

An Intro to Pulse Circuits – Series Noise Clipping Using Diodes

Posted on December 9, 2011 by glent

Welcome back to my workbench, The Big Idea – Series Noise Clipping Circuits. Frequently, unwanted noise in signals can trigger sensitive circuits. A series noise clipper can be used to eliminate this noise. Drill Down: If the noise is smaller … Continue reading →

Posted in Basic Electronics | Tagged , | Leave a comment

An Intro to Pulse Circuits – part 8: Diode Clipping Circuits

Posted on November 22, 2011 by glent

Welcome back to my workbench, The Big Idea – Diode Clipping Circuits Circuits that select part of an input waveform for transmission are referred to as voltage (or current) clippers, limiters, slicers or amplitude selectors.. Drill Down: The positive series … Continue reading →

Posted in Basic Electronics | Tagged , , , | Leave a comment